This code dumps the raw IR code length when detected.
#include <IRLibRecvPCI.h>
IRrecvPCI myReceiver(5); // Arduino ZERO pin 5
void setup() {
SerialUSB.begin(9600);
myReceiver.enableIRIn();
SerialUSB.println("Ready to receive IR signals");
SerialUSB.println("Point the remote controller to the IR receiver and press!");
}
void loop() {
if (myReceiver.getResults()) {
// SerialUSB.println("\n\n-------------------------");
SerialUSB.println("\nReceived IR signal:");
SerialUSB.print(F("#define RAW_DATA_LEN "));
SerialUSB.println(recvGlobal.recvLength, DEC);
// SerialUSB.print(F("uint16_t rawData[RAW_DATA_LEN]={\n"));
// for (bufIndex_t i = 1; i < recvGlobal.recvLength; i++) {
// SerialUSB.print(recvGlobal.recvBuffer[i], DEC);
// SerialUSB.print(F(", "));
// if ((i % 8) == 0) {
// SerialUSB.print(F("\n"));
// }
// }
// SerialUSB.println(F("1000};"));
// SerialUSB.println("-------------------------");
myReceiver.enableIRIn();
}
}BOARD?=arduino:samd:mzero_bl
PORT?=/dev/cu.usbmodem14*
.PHONY: default lint all flash clean
default: lint all flash clean
lint:
cpplint --extensions=ino --filter=-legal/copyright,-whitespace/line_length *.ino
all:
arduino-cli compile --fqbn $(BOARD) ./
flash:
arduino-cli upload -p $(PORT) --fqbn $(BOARD)
clean:
rm -r build